Hartrees to Therms calculator

Hartrees to Therms Conversion Table

Below you can generate and download as CSV, Excel, PDF or print the Hartrees to Therms conversion table based on your needs.

Selected rounding: none (You can change it above in the dropdown)

• Therm (105,505,600 J)

  Not to be confused with Thermies unit. The therm (symbol, thm) is a non-SI unit of heat energy equal to 100,000 British thermal units (Btu). It is approximately the energy equivalent of burning 100 cubic feet (2.83 cubic metres) – often referred to as 1 CCF – of natural gas. Since natural gas meters measure volume and not energy content, a therm factor is used by natural gas companies to convert the volume of gas used to its heat equivalent, and thus calculate the actual energy use. The therm factor is usually expressed in units of therms per CCF. It will vary with the mix of hydrocarbons in the natural gas. Natural gas with a higher than average concentration of ethane, propane or butane will have a higher therm factor. Impurities, such as carbon dioxide or nitrogen, lower the therm factor. One therm is equal to about 105.5 megajoules, 25200 kilocalories, or 29.3 kilowatt-hours. One therm can also be provided by about 96.7 cubic feet (2.74 m3) of natural gas. The therm sometimes has been confused with the thermie. The names of both units come from the Greek word for heat.

• Hartree (0.0000000000000000043 J)

  The hartree (symbol: Eh or Ha), also known as the Hartree energy, is the atomic unit of energy, named after the British physicist Douglas Hartree. It is defined as 2R∞hc, where R∞ is the Rydberg constant, h is the Planck constant and c is the speed of light. The 2014 CODATA recommended value is Eh = 4.359 744 650(54)×10−18 J = 27.211 386 02(17) eV. The hartree energy is approximately the electric potential energy of the hydrogen atom in its ground state and, by the virial theorem, approximately twice its ionization energy; the relationships are not exact because of the finite mass of the nucleus of the hydrogen atom and relativistic corrections. The hartree is usually used as a unit of energy in atomic physics and computational chemistry: for experimental measurements at the atomic scale, the electronvolt (eV) or the reciprocal centimetre (cm−1) are much more widely used.